Drawmer MX PRO MX60 Especificaciones

DRAWMERMX60FRONT END ONEOPERATORS MANUALCONTENTSSAFETY CONSIDERATIONS page 2INSTALLATION page 3 INTRODUCTION page 4• Audio Connections page 6• Power C

DYNAMICS STAGEGATEThreshold Sets the threshold below which signal is assumed to benoise and therefore muted. Setting the control fullyclockwise turns

EQUALISER STAGEL.F Cut/ Boost High-pass shelving filter providing up to 18dB of cut orboost below the turnover frequency of 100Hz.Mid ParametricFreque

OUTPUT STAGEMaster Fader Sets the overall output level of the MX60 from off to+15dBu. An eight-section LED mater shows the output levelfrom ! 20dBu to

OPERATIONPreampFor use as a front end, the MX60 may be connected directly to the line input ofa tape recorder, hard disk recorder, mixer or other line

may be an audible tonal change in the voice during sibilant sounds, in whichcase the control should be backed off. The de-esser may also be effective

Tubesound The Tubesound section is a purely creative tool, so it's up to you how you useit. To create subtle tube amp or tube mic effects, apply

IF A FAULT DEVELOPSFor warranty service please call Drawmer Electronics Ltd. Or their nearestauthorised service facility, giving full details of the d

TECHNICAL SPECIFICATIONS(Measurements taken using +4dBu balanced input where applicable)INPUT IMPEDANCE 20KS (bal), 20KS (unbal)MAXIMUM INPUT LEVEL +2

BLOCK DIAGRAM18

19

COPYRIGHTThis manual is copyrighted © 2011 by Drawmer Electronics, Ltd. With all rightsreserved. Under copyright laws, this manual may not be duplicat

20

DRAWMER MX60Front End OneSAFETY CONSIDERATIONSCAUTION - MAINS FUSETO REDUCE THE RISK OF FIRE REPLACE THE MAINS FUSE ONLY WITHTHE SAME TYPE, WHICH MUST

INTRODUCTIONThe MX60 is a high quality mic/line preamplifier with integral gate, de-esser,compressor, parametric equaliser and peak limiter.

A conventional de-esser can be set up by introducing equalisation into theside-chain of a compressor and adjusting the equaliser so

AUDIO CONNECTIONSInput and Output connections are provided for use at +4dBu via balancedXLRs for Mic. Line is either at +4dBu via a Balanced jack or a

AUDIO CONNECTION DIAGRAM7

Accessing the internal power switch and fusePOWER CONNECTIONIf, for some reason, the unit is to be operated at a mains input voltage which isdifferent

CONTROL DESCRIPTIONINPUT PRE-AMP STAGEThe preamplifier section is based around Drawmer's own discrete componentmic preamp similar to that use in